Insulation Company in Sunland, CA
Blown in insulation is the most common fix we install in Sunland, because so many of the homes here were built between the 1950s and 1970s with attics that have never been upgraded. The original fiberglass batts have settled, compressed, and stopped doing their job in a climate that regularly pushes attic temperatures past 130 degrees in summer. Porch Light Insulation has served Sunland since 2014, and we match the material to your home, not to our inventory. Call (877) 521-4987 for a free estimate.
Why Sunland Homes Are Different
Sunland sits at the base of the Verdugo Mountains, where summer heat routinely spikes into triple digits and unshaded foothill-facing walls absorb sun all afternoon. Insulation here is as much about keeping heat out as it is about holding warmth in. The housing stock is dominated by 1950s-1970s single-story ranch and tract homes on the valley floor, plus stepped hillside houses tucked into the Verdugo foothills. Many of these homes still have original or severely undersized attic insulation that has settled over decades. Some older homes have minimal wall cavity insulation at all. South- and west-facing roofs take the worst solar load, and we routinely find attics with no radiant barrier under tile or composition roofs. In the hillside streets toward the foothills, attic temperatures climb so high by midday that we schedule insulation installs for early morning, before the roof deck turns into a heat sink. That is a scheduling reality specific to Sunland, and it changes how we approach every job here.
Our Main Sunland Services
Most Sunland homeowners call us about two things: an attic that is turning the upstairs into an oven in summer, or air leaks and drafts that make winter mornings miserable. Here is how each job works in Sunland.
Attic Insulation in Sunland
Attic insulation in Sunland usually means removing or topping off what is already up there and then air sealing the ceiling plane so the conditioned air you pay for stays in the living space. On 1950s and 1960s ranch homes, we often find settled fiberglass batts that have compressed to a fraction of their original R-value, leaving the ceiling effectively uninsulated in spots. The hillside homes add a wrinkle: attic access hatches are sometimes in awkward spots, and the roof pitch can make working conditions tight. But the payoff is immediate, especially in August when the attic temperature drives heat down through the ceiling. Read more about Attic Insulation in Sunland.

Spray Foam Insulation in Sunland
Spray foam insulation in Sunland is a strong fit for hillside homes with hard-to-reach attic cavities, knee walls, and floor systems over garages where air movement is the real culprit. Closed-cell spray foam also acts as a vapor control layer, which matters in the foothills where winter nights get cold enough to create condensation risk inside unsealed roof decks. Open-cell foam, on the other hand, is excellent for air sealing without the higher per-board-foot cost, and the brands we install, including Demilec and Icynene, give us options for budget-conscious and performance-first homes alike. Read more about Spray Foam Insulation in Sunland.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Blown In Insulation in Sunland

Blown in insulation is the workhorse solution for Sunland attics because it fills irregular cavities, covers settled or compressed older material, and brings the whole attic up to current code performance without tearing out drywall. Most Sunland homes we inspect have attics that are decades old, with original fiberglass or rock wool that has compressed to a fraction of its original depth. Blown-in cellulose and blown-in fiberglass both solve that problem fast, and they are the most cost-effective way to get a 1950s ranch home through a triple-digit summer. We install Blown In Insulation in attics across Sunland, from the valley floor to the Verdugo foothills, and we schedule hillside jobs early so the roof deck has not had all day to bake.
Cellulose Insulation
Signs you need it
Your attic insulation is thin, dusty, or settled well below the top of the ceiling joists, and rooms directly under the attic get hot within an hour of sunrise in summer.
What it costs in Sunland
Blown-in cellulose in a Sunland attic typically runs $1.40 to $2.20 per square foot installed, depending on depth and whether we are topping off existing material or starting fresh.
How we do it
We air seal the ceiling plane penetrations first, then blow GreenFiber or an equivalent cellulose product to the target depth using a calibrated hopper and hose, testing depth as we go.
Blown In Attic Insulation
Signs you need it
Rooms directly under the attic swing from hot to cold with the weather, and your energy bills show that the air conditioner runs harder than it should in summer.
What it costs in Sunland
A full attic blow-in for a typical 1,200-square-foot Sunland ranch home runs $1,600 to $2,800, with material and labor included.
How we do it
We arrive early to avoid the worst of the roof heat, set up containment at the access point, and blow the material evenly across the entire attic floor to the specified R-value.
What Blown In Insulation Costs in Sunland
| Item | Typical range in Sunland |
|---|---|
| Blown-in fiberglass or cellulose per square foot | $1.25 – $2.20 |
| Full attic blow-in, 1,200 sq ft ranch home | $1,600 – $2,800 |
| Top-off over existing attic insulation | $700 – $1,400 |
How much does blown in insulation cost in Sunland?
In Sunland, blown in insulation runs $1.25 to $2.20 per square foot installed, so a typical 1,200-square-foot attic costs between $1,600 and $2,800. Hillside homes with tight access can push toward the upper end. Call (877) 521-4987 for a quote specific to your attic.
Can you do blown in insulation the same day?
Yes, most blown in attic jobs in Sunland are completed in a single visit, usually three to five hours depending on attic size and access. We schedule hillside jobs for early morning to keep install conditions manageable. Call (877) 521-4987 to check this week’s schedule.
Brands We Service in Sunland
We carry an eight-brand bench that includes Owens Corning, Johns Manville, GreenFiber, Demilec, and Rockwool, so the material fits the application rather than whatever is in the truck. Parts and materials are stocked locally for Sunland jobs, which means most installs are scheduled within a week of the estimate. Read more about our brands.
Pricing for Insulation Company in Sunland, CA
| Service | Typical range in Sunland |
|---|---|
| Attic insulation, full install | $2,100 – $4,300 |
| Blown-in attic insulation (1,200 sq ft) | $1,600 – $2,800 |
| Cellulose insulation per square foot | $1.40 – $2.20 |
| Blown-in fiberglass per square foot | $1.25 – $1.70 |
| Attic insulation top-off | $700 – $1,400 |
| Spray foam insulation per square foot | $1.75 – $4.25 |
| Mineral wool batts per square foot | $1.90 – $3.10 |
Hillside homes with tough attic access and older Sunland ranches that need air sealing before insulation will land on the higher side of these ranges. We quote a firm upfront price before work starts, so the number you hear on the estimate is the number you pay.
Neighborhoods We Serve in Sunland
We work throughout Sunland and the 91040 and 91041 ZIP codes, from the flat ranch tracts near Foothill Boulevard up into the hillside streets toward the Verdugo foothills. Our crews know which houses tend to have settled attic insulation and which attics bake hardest in the afternoon.
- Sunland hillside communities
- Foothill Boulevard corridor
- Canyon-adjacent streets near the Verdugo foothills
- Valley floor ranch tracts
- Shadow Hills border area
Most Sunland estimates are scheduled within 48 hours, and we can often have an inspector out the same week you call.
Service Area – Cities Near Sunland
Sunland sits in the northeast San Fernando Valley near the Verdugo foothills, and our service area stretches from the hillside communities of Shadow Hills, CA and Tujunga, CA to the neighboring corridors of La Crescenta-Montrose, CA and Burbank, CA. If you live near Sunland and need attic, blown-in, or spray foam insulation, call (877) 521-4987.
Serving Sunland, CA — Our Local Coverage Area
We’re based in the Sunland area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Insulation Company in Sunland
We can usually get a Porch Light estimator to a Sunland home within 48 hours of your call, and in many cases the same week. Hillside jobs are scheduled for early morning when the attic is at its coolest. Call (877) 521-4987 to check availability.
In most Sunland homes, adding attic or blown-in insulation does not require a permit because it is considered a like-for-like upgrade. Spray foam can sometimes trigger a check depending on the project scope, and we handle that conversation for you. We will tell you upfront if a permit applies.
Yes, we regularly insulate hillside and canyon-adjacent Sunland homes, including those with steep driveways and tight attic access. We schedule those jobs for early morning so the roof deck has not been baking in the afternoon sun all day before our crew starts.
What happens when you call
- 1A real person answersNo phone trees — talk to a local insulation pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What Sunland Customers Say
"He did a blower door test before and after and gave me the numbers. I like being able to see the difference rather than being told about it."
— Ruben Garcia"Handled the utility rebate paperwork, which knocked a real amount off the final cost."
— Adam Parker"Installed baffles at the soffits so the new insulation didn't block the ventilation, which the previous contractor apparently never considered."
— Cole Rhodes